Temporary Fix Pull over and set the transmission in Park. Please turn off the ignition, then turn it back on. Pull the parking brake switch and keep it for 10 seconds, then release it. Start the engine, and the light, in most cases, will turn off. Here is a list of common problems that cause the Parking Brake to stay on.
Faulty Switch: One common reason for the Parking Brake light to stay on is a failing or failed switch. This can be checked easily by moving the handle to and fro after it is down. If the light turns off (or turns off and then back on), the switch is the most likely culprit and will need to be replaced.
If the parking brake light doesn't turn off, several troubleshooting steps can be taken to identify the issue. These include-1. Checking The Parking Brake Switch . The parking brake switch is under the parking brake lever or pedal. Ensure the parking brake lever or pedal is fully released to check the button.
There are usually two possible reasons why your parking brake warning light stays on after you've released the parking brake: The parking brake is not fully disengaged. This means that releasing the pedal, lever or button did not completely release the actual parking brake.
Apply the parking brake, then remove the floor console rear finish panel. Apply the parking brake. Remove the floor console finish panel. Remove the adjustment nut clip. Turn the parking brake control adjustment nut so that the parking brake control stroke is three to five notches when pulled.
Most likely it is the parking brake switch stuck or the wiring to it is damaged. If you move the switch by hand will it stop? Do you have a tool for testing electrical so we can do some tests?
VhsiF. q6fzexu1b7.pages.dev/218q6fzexu1b7.pages.dev/74q6fzexu1b7.pages.dev/398q6fzexu1b7.pages.dev/342q6fzexu1b7.pages.dev/597q6fzexu1b7.pages.dev/375q6fzexu1b7.pages.dev/68q6fzexu1b7.pages.dev/550
parking brake alarm won t turn off
